BABYSTYLE OYSTER Instruction Manual - page 5
FITTING AND REMOVING THE REAR WHEELS
Hold the rear wheel and insert the rear wheel axle stub into the hole in
the rear axle. Push in completely until you hear a click. Pull the
wheel to check it is locked on. To remove the rear wheel push in and
hold the rear wheel quick release lever (on the rear axle) and pull the
rear wheel from the axle.
NOTE, the axle stubs can become greasy and
may leave marks on other surfaces they come into contact with. To
prevent marking clean the axle stubs with a cloth.
shoulder straps should be clipped into the centre buckle at the end of
the crotch strap. The harness can be adjusted to suit your child by
sliding the adjusters along the shoulder straps and waist belts. To
release the safety harness, push the buttons on the centre buckle. D-
rings for attaching a separate harness can be found attached to the
integral harness at the base of the waist straps. The crotch strap can
be adjusted to suit your child. There are two button holes in the seat
base. Thread the buckle through the hole in the plastic seat base and
then through the opening in seat covers and reposition, passing back
through first the seat cover and then through the opening in plastic
seat base. The shoulder straps can be adjusted to two positions’,
thread the buckle through the hole in the plastic seat back and
through the opening in the seat cover and reposition passing first
through the seat cover and then through the opening in the plastic
seat back. Ensure that both shoulder straps are at the same level and
that both are secure.
OPERATING THE SWIVEL FRONT WHEELS
The front wheels can be used in swivel-wheel or fixed-wheel mode.
To switch from locked to swivel; press down the swivel wheel lock
buttons (left & right), to switch back to locked; press again and the
wheels will lock automatically when they return to the travel forwards
position.
ADJUSTING THE HANDLE HEIGHT
The handle height is adjustable to four positions. To adjust the handle
height, press-in and hold in the button in the middle of the handle grip,
slide the handle up or down to one of the four positions. The handle
will click into one of the pre-set positions when the button is released.
WARNING Always use the crotch strap in combination with the
waist belt.
USING THE PARKING BRAKE
ALWAYS USE THE SAFETY HARNESS
To engage the brake, firmly press down with your foot the brake lever
found in the middle of the rear axle. Check that the brake is fully
engaged before letting go of the handle. To release the brake, with
your foot press forwards or lift up the brake lever until the wheels
move freely.
HOOD/SUN CANOPY/INSECT NET
The Oyster has a multi function hood that helps to protect your child
from the elements. The hood has four sections and a concealed
insect net. The hood can also be removed altogether.
NEVER Leave the vehicle without first engaging the brake.
TO REMOVE/ FIT THE HOOD
Release the two press-studs at the back of the hood where the hood
attaches to the backrest. Release the Velcro fastening just above the
two press-studs. Fold the hood back; hold the hood by the frame in
the centre and pull the hood up in line with the back rest, the hood will
slide away from the fittings on the side of the seat back rest. To fit the
hood. Line up the plastic components on the hood sides (one left,
one right) and slide them into the corresponding plastic parts on the
sides of the seat back rest. Push them down until they click into
position. Fasten the Velcro on the hood to the seat back and secure
the press-studs
Up brake off
Down brake on
12
5