BABYSTYLE OYSTER Instruction Manual - page 8
FITTING AND REMOVING THE BUMPER BAR
FITTING THE OYSTER CAR SEAT
(model LB321)
TO THE CHASSIS
Push the ends of the bumper bar into the corresponding slots on the
seat unit until the bumper bar locks into position. To remove the
bumper bar, press in the bumper bar release button on the side of the
seat; one on the right side one on the left side. The position of the
bumper bar can be adjusted by pressing the buttons on the insides of
the bumper bar.
Matching Oyster car seat is fitted to the chassis by using the LB321
Oyster car seat adaptors. The car seat can not be attached to the
chassis until the seat unit or the carrycot has been removed.
Insert the car seat adaptors into the Oyster chassis attachment
device, the adaptors are marked “R” and “L” for right and left. Push
down on the adaptors until they click and lock into position. Hold the
car seat by the carry handle and lower the car seat onto the car seat
adaptors. The adaptors should slot into the cavity at the base of the
car seat handle left and right. Push the car seat down firmly until the
car seat clicks and locks into position. Check that the car seat is
secure and locked by pulling up on the car seat handle.
FITTING THE CARRYCOT TO THE CHASSIS
The Carrycot can only be fitted to the chassis when the seat unit or
car seat has been removed. The carry cot can only be fitted to the
chassis facing the handle. Lower the carry cot so that the fittings in
the middle of the carrycot line up with the attachment device. Push
the carrycot down until it clicks into position. Check that the carrycot
is securely attached by trying to lift the carrycot from the chassis.
REMOVING THE OYSTER CAR SEAT
(model LB321)
FROM THE
CHASSIS
To remove the car seat from the chassis; press down on the two red
buttons on the sides of the car seat (not the handle adjustment
buttons where the handle turns) and lift the car seat away from the
chassis.
REMOVING THE CARRYCOT FROM THE CHASSIS
To remove the carrycot from the chassis:
Hold the carry cot by the two release
Handles, and pull the handles up
To remove the adaptors on the Oyster chassis pull up on the
recessed handles and lift the adaptors away from the attachment
device.
with your fingers. The carrycot will be
released from the attachment device.
Children should be clear of moving
parts while making adjustments.
8
9
CAR SEAT ADAPTORS
Carrycot release handles
LOWERING THE CARRYCOT HOOD
The carrycot hood can be lowered (reclined backwards) by pressing in
the two buttons (left & right) at the outside base of the hood opening.
Push in the buttons and recline the hood. To erect the hood; lift up
the hood until it clicks into position.