1. DL manuals
  2. BABYSTYLE
  3. Stroller
  4. OYSTER
  5. Instruction Manual

BABYSTYLE OYSTER Instruction Manual

Manual is about: 20 kg weight limit

Summary of OYSTER

  • Page 1

    I n s t r u c t i o n m a n u a l register your product at www.Babystyledirect.Co.Uk.

  • Page 2: C O N T E N T S

    Page important safety information 3 primary features 4-5 fitting and removing the front wheels 6 fitting and removing the rear wheels 7 operating the swivel front wheels 8 adjusting the handle height 8-9 using the parking brake 9 opening the chassis 10 fitting the seat unit 11 removing the seat unit...

  • Page 3

    1. Warning: a child’s safety is your responsibility 2. Warning it may be dangerous to leave your child unattended. 3. Warning ensure that all locking devices are engaged before use. 4. Warning do not use a mattress thicker than 35mm 5. This vehicle is intended for children from birth to a maximum we...

  • Page 4

    P r i m a ry f e at u r e s handle grip zip for extendable canopy handle height adjustment seat unit release handle attachment device shopping basket unfolding sliders rear wheel quick release parking brake backrest recline lever 4.

  • Page 5

    Footrest leg rest bumper bar swivel wheel locks bumper bar release button concealed insect/shade net flip out canopy front wheel quick release 5.

  • Page 6: Fitting and Removing The

    Fitting and removing the front wheels push in the front wheel quick release button on the front wheel housing and push the wheel unit onto the front wheel axle stub until it stops. Release the quick release button and check that the wheel is locked on. To remove the wheel; push in the front wheel qu...

  • Page 7: Fitting and Removing The

    Fitting and removing the rear wheels hold the rear wheel and insert the rear wheel axle stub into the hole in the rear axle. Push in completely until you hear a click. Pull the wheel to check it is locked on. To remove the rear wheel, push in and hold the rear wheel quick release lever (on the rear ...

  • Page 8: Operating The Swivel

    Press down for swivel-wheel mode operating the swivel front wheels the front wheels can be used in swivel-wheel or fi xed-wheel mode. To switch from locked to swivel; press down the swivel wheel lock buttons (left & right), to switch back to locked; press again and the wheels will lock automatically ...

  • Page 9: Using The Parking Brake

    Using the parking brake to engage the brake, fi rmly press down with your foot the brake lever found in the middle of the rear axle. Check that the brake is fully engaged before letting go of the handle. To release the brake, with your foot press forwards or lift up the brake lever until the wheels m...

  • Page 10: Opening The Chassis

    Opening the chassis release the chassis locking clip by pushing it outwards and pull up on the handle. The chassis will start to open and will click when the handle tube is locked in line with the lower tube. Press the chassis locking clip lift the seat backrest recline lever warning! To avoid injur...

  • Page 11: Fitting The Seat Unit

    Fitting the seat unit to fi t the seat unit to the chassis: hold the seat unit by the seat unit release handles and lower the seat unit into the attachment devices left & right. Push down until the seat clicks and locks into position. Ensure the seat is locked into position by trying to pull the seat...

  • Page 12: Folding The Chassis

    Always ensure the child is clear of moving parts while making adjustments folding the chassis to fold the chassis there are three steps, it is important that each step is fully complete before moving onto the next: step 1: standing in the pushing position locate the sliders on each side of the chass...

  • Page 13: Folding The Chassis With

    Step 3: with the button held fully down and the sliders fully pulled back, lift the whole handle and push away from yourself. If the handle does not move easily it is likely that the button is not fully pressed down and/or the sliders are not fully pulled back, if this happens repeat steps 1 and 2 u...

  • Page 14: Fitting The Carrycot To

    Fitting the carrycot to the chassis the carrycot can only be fi tted to the chassis when the seat unit or car seat has been removed. The carry cot can only be fi tted to the chassis facing the handle. Lower the carry cot so that the fi ttings in the middle of the carrycot line up with the attachment de...

  • Page 15: Lowering The Carrycot

    Lowering the carrycot hood the carrycot hood can be lowered (reclined backwards) by pressing in the two buttons (left & right) at the outside base of the hood opening. Push in the buttons and recline the hood. To erect the hood; lift up the hood until it clicks into position. Fitting and removing th...

  • Page 16: Fitting The Oyster Car

    Fitting the oyster car seat (model lb321) to the chassis the matching oyster car seat is fi tted to the chassis by using the lb321 oyster car seat adaptors. The car seat can not be attached to the chassis until the seat unit or the carrycot has been removed. Insert the car seat adaptors into the oyst...

  • Page 17: Removing The Oyster Car

    Removing the oyster car seat (model lb321) from the chassis to remove the car seat from the chassis; press down on the two red buttons on the sides of the car seat (not the handle adjustment buttons where the handle turns) and lift the car seat away from the chassis. To remove the adaptors on the oy...

  • Page 18: Oyster Car Seat Adaptors

    Oyster car seat adaptors car seat options the oyster chassis can be combined with car seats from other leading brands. For details, see the table below. Always check with your retailer that you have the correct car seat adaptors if adaptors are required. Note: the britax baby-safe plus shr ii requir...

  • Page 19: Oyster Chassis Using The

    Fitting a car seat to the oyster chassis using the multi adaptors the car seat can not be attached to the chassis until the seat unit or the carrycot has been removed. Insert the car seat adaptors into the oyster chassis attachment device, the adaptors are marked “1” and “2”, 1 is right and 2 is lef...

  • Page 20: Oyster Harness

    Oyster harness shoulder strap and buckle shoulder strap and buckle waist belt & buckle waist belt & buckle centre harness buckle crotch strap buckle removing the britax baby- safe shr car seat from the oyster chassis hold the carry handle of the car seat and press one of the buttons on the top of th...

  • Page 21: Using The Safety Harness

    Using the safety harness always apply the parking brake before placing your child in the vehicle. The safety harness has two shoulder straps, two waist belts and a crotch strap. Place the two shoulder straps over the child’s shoulders and the waist belts around the child’s waist. The crotch strap sh...

  • Page 22: Hood/sun Canopy

    Hood/sun canopy the oyster has a multi function hood that helps to protect your child from the elements. The hood has four sections and a viewing window. The hood can also be removed altogether. To remove/ fit the hood release the two press-studs at the back of the hood where the hood attaches to th...

  • Page 23: Flip Out Canopy

    Flip out canopy the front section of the hood can be fl ipped out or folded back into the main part of the hood depending choice. To fl ip out the canopy hold the front part of the canopy and pull forwards. To fold the canopy away push it back into the hood and smooth the fabric. Zippered canopy exten...

  • Page 24: Insect / Shade Net

    Insect / shade net concealed in a zippered pocket underneath the leg rest is the insect/shade net. Unfasten the zip and unfurl the insect/shade net. The elasticated top part of the insect/shade net attaches over the hood frame. There are two velcro tabs on the sides of the net which fasten to the si...

  • Page 25: Fitting The Footmuff

    Fitting the footmuff the footmuff top cover can be removed by unfastening the zip. The base of the footmuff can be used as a seat liner without the top part. To attach the footmuff to the seat unit: release the harness clips from the centre buckle and release the shoulder straps from the waist belts...

  • Page 26

    Regularly check screws, rivets, bolts & fastenings to ensure • they are locked tight and secure. Replace any parts in an inferior condition. Should you intend to use the pushchair during the winter, by the sea or off-road; it is important to clean thoroughly & dry the vehicle after use. Salt from th...

  • Page 27: Wa R R A N T Y

    A stroller has many moving parts and requires regular maintenance by the user. Simple cleaning and lubricating will make the stroller look good & operate better for longer. The stroller will be used in many different environments, country walks, a trip to the coast; a winter’s walk to school, all ca...

  • Page 28: Www.Oysterstroller.Com

    Babystyle uk limited le12 7rj united kingdom this instruction manual babystyle uk limited 2013 all rights reserved. Oyster ajb1620/12062013 www.Oysterstroller.Com.