BABYSTYLE OYSTER Instruction Manual - Oyster Chassis Using The
FITTING A CAR SEAT TO THE
OYSTER CHASSIS USING THE
MULTI ADAPTORS
The Car Seat can not be attached to the chassis until the seat
unit or the Carrycot has been removed.
Insert the Car Seat adaptors into the Oyster chassis attachment
device, the adaptors are marked “1” and “2”, 1 is right and 2 is
left. Push down on the adaptors until they click and lock into
position. Hold the Car Seat by the carry handle and lower the
Car Seat onto the car seat adaptors, the adaptors should slot
into the cavity at the base of the Car Seat handle left and right.
Push the car seat down fi rmly until the car seat clicks and locks
into position. Check that the Car Seat is secure and locked by
pulling up on the Car Seat handle.
REMOVING A CAR SEAT FROM
THE OYSTER CHASSIS WHEN
FITTED WITH THE MULTI
ADAPTORS
To remove the Car Seat from the chassis: Press down on the
two buttons on the sides of the Car Seat (not the handle
adjustment buttons used to operate the handle recline) and lift
the Car Seat away from the chassis.
To remove the adaptors from the OYSTER chassis pull up on
the recessed handles and lift the adaptors away from the
attachment device.
FITTING The Britax BABY-
SAFE plus SHR TO THE OYSTER
CHASSIS
(no adaptors required)
The Car Seat can not be attached to the chassis until the seat
unit or the carrycot has been removed. The Britax Baby Safe
plus SHR does not require adaptors to fi t onto the OYSTER
chassis. Hold the car seat by the carry handle and lower the
car seat onto the chassis so that the fi ttings below the car seat
handle slide into the attachment device on the OYSTER chassis.
Push the car seat down fi rmly until the car seat clicks and locks
into position. Check that the car seat is secure and locked by
pulling up on the car seat handle.
19