Baijia BJ-05 Operation Manual - page 23
5.4.4 Batch Preset Mode
Press the button for each time, the batch number display will be shown 10, 20 , 25 , 5 0,
100, blank. Then press the button once again, the batch number display can add 1 at the
same time. If you press the button steadily, the display will auto add 1 every 1/4 second.
This function will be off after pressing button again.
Put the banknotes in the hopper, the unit will count automatically. It will stop counting until reaching
the batch number. The batch number shown on the counting number display will be cleared when
taking out the counted banknotes from the stacker however there is or not banknote in the hopper.
If you want to repeat the batch counting, there are two ways for your choice. The first is taking out
the counted banknotes from the stacker. The second is pressing the switch without taking
out the counted banknotes. The unit can repeat automatically the above course.
If the batch number isn't reached, the counting number which in the counting number display will be
flashed until putting more banknotes in the hopper, the unit will go on counting and stop until
reaching the batch number.
Change the batch number each time means stop the current batch counting mode, the counted
banknotes in the stacker should be taken out and set the new batch number.
17
BATCH
Operation
Self-
checking
Feeding
Operation
Button
Function
Counting
Mode
Outer
Display
Detection
Sensitivity
Adjustment
BATCH
RESTART
RESTART
CLEAR
CLEAR