Baijia BJ-05 Operation Manual - page 29

After using some times, if the counting number is wrong and not smooth dropping, because the 

resistance rubber tongue is wore and tore a little. It needs to be modified or changed.

    When the resistance rubber tongue is wore and tore a little, adjust and raise the hopper plate

    by turning the screw counterclockwise. It is about 0.5mm from the banknote feeding rubber

    wheel to the resistance rubber tongue mine and keep the friction.

REMARK: if the counting number is wrong, it is better to turn the adjustable screw just one or two 

                   rolls during using.

   When it is wore and tore too much ,press down the hopper plate by your thumb and take it out. 

    Change the other side to use or a new one.

   The fixed position of resistance rubber tongue must be returned to the limited point during

    installation. The left and right sides must be kept balanced.

    After finishing the above operation, turn on the unit and take one piece of banknote to feed in 

    the hopper, you can feel little pull-force from the banknote feeding rubber wheel, which is 

    balanced in the left and right side. 

6.2 Resistance Rubber Tongue Adjustment

23

Operation

Self-

checking

Feeding

Operation

Button 

Function

Counting 

Mode

Outer 

Display

Detection 

Sensitivity 

Adjustment