Baijia BJ-05 Operation Manual - page 28
It should be taken down single to change. At first loose out the fastening screw of rear cover Open
the rear cover little, then loose out the fastening sheet screw of the hopper. The up and down
adjustable screw could be tweaked out by turning counterclockwise. At last drive up the back of
hopper little by little and pull it out backward..
When turning the up and down adjustable screw clockwise, the hopper will drop down, the gap
between the banknote feeding rubber wheel and the resistance rubber tongue will increase to reduce
the friction. All of the course will be counter by turning the screw counterclockwise.
The two sides fixed spring in front of hopper is clamped correctly at the pivot of the fastening screw
of left and right boards. The hopper could be moved under up and down or left and right or front and
rear freely.
REMAKR: put out the hopper slightly to avoid disconnecting the hopper sensor connecting wire which
locate at the bottom plate of hopper.
6.1 Hopper Adjustment
6.0 Spare Parts Adjustment
22
Operation
Self-
checking
Feeding
Operation
Button
Function
Counting
Mode
Outer
Display
Detection
Sensitivity
Adjustment