Bakers Pride BCO-G Installation And Operating Instructions Manual

Manual is about: CYCLONE SERIES FULL-SIZE GAS CONVECTION OVENS

Summary of BCO-G

  • Page 1

    Installation and operating instructions cyclone series gas convection ovens models: bco-g and gdco-g intended for other than household use. Retain this manual for future reference. Oven must be kept clear of combustibles at all times. This equipment has been engineered to provide you with year round...

  • Page 2

    Table of contents a receiving 2 b set up / mounting 3 c installation with casters (optional) 4 d location and minimum clearances 4 e gas connections 4 f electrical connection 5 g flue connection ventilation 5 h burner operation 6 i system check rotary control 6 j programming menus 6 a general instru...

  • Page 3

    3 your oven will be packed sitting on its bottom. The skid may be left under the oven for convenience in further handling. Unpack carefully, avoiding damage to the stainless steel front and/or trim. If concealed damage is found, follow the instructions detailed in section a (receiving). Keep the are...

  • Page 4

    Fit the standard flue diverter supplied into the hole in the top of the oven for under ventilation hood installation and secure with screws. For direct venting, flueadapter and draft hood must be placed into the hole on top of the oven. Four casters (two with wheel brakes) and the mounting hardware ...

  • Page 5

    The gas pressure regulator is part of the combination valve and is adjusted to yield a pressure of 3.5” water column (9 mbar) for natural gas. If the oven is ordered for use on propane gas or butane, the pressure regulator in the combination valve is preset at the factory to yield a pressure of 10” ...

  • Page 6

    Optional direct venting (not available for european community countries): note: do not put a damper in the flue and do not connect a blower directly to the flue. H. Burner operation: i. System check- rotarycontrol: note: oven starts heating as soon as the set temperature is higher than the oven temp...

  • Page 7

    Ii. Operating instructions a. General instructions: b.Operation sequence rotarycontrol: cook only rotary control: timed cooking rotary control: note: timer isasignal deviceonlyanddoes not control the oven. Cook and hold rotary control: (1) this equipment has an electronic temperature control and ele...

  • Page 8

    8 optional steam injection: rotary control: note: do not use steam injection at temperatures below 275°f (135°c). Oven cool down rotary control: c.Cleaning: clean only when oven is cold keep cleaning fluids away from electrical wires, light sockets, switchesandcontrolpanel. Note: always rub the stai...

  • Page 9

    2 1 3 attach part # 21818062 with 6 each 8-32 stainless screws remove the outer and inner flue from the bottom oven before placing the top oven (to prevent damaging the bottom oven’s flue). Re-install after top oven is positioned. Material: 14 ga 201 stainless figure 3 stacking instructions for: bco...

  • Page 10

    With plate caster without plate caster leg assembly instructions-model: bco-g & gdco-g figure 4 1. Attach two item 2 to two item 1 using item 3, 4 and 5. 2. Using proper lifting equipment attach item 1 to the 4 corresponding hole patterns located in the bottom of the ovenwith item 6. 1 2 3 4 5 6 1 2...

  • Page 11

    Single-phase 120v wiring diagram (push-button control) ground stud t2 t3 t4 t5 t1 t8 t9 t7 t6 t12 t13 t11 t10 door switch probe 37 39 lights 120v low high 120v 24v probe igniter flame sensor transformer relay 4 postion door switch power switch pushbutton switch ch104 control combination valve green ...

  • Page 12

    Black p1 p2 p3 p4 com nc no t6 t7 t8 t9 t10 t11 blue 4 1 2 3 yellow groundstud power light t-stat light switch lights buzzer 60 min timer power switch door switch flame sensor igniter high low centrifugal switch fan motor com 120v white ground 24v 4 pos switch t-stat light ground stud groundstud pro...

  • Page 13

    13 parts list model number: bco g & gdco-g - type of gas: natural l.P. Other 30 pine street • new rochelle • new york • 10801 914 / 576 - 0200 914 / 576 - 0605 1 - 800 - 431 - 2745 www.Bakerspride.Com fax us & canada web address bakers pride cyclone series 4/05 note: when ordering, always specify pa...

  • Page 14

    14.

  • Page 15

    15.

  • Page 16

    16 bakers pride limited warranty 30 pine street new rochelle, new york 10801 914 / 576 - 0200 • us & canada: 1 - 800 - 431 - 2745 • fax 914 / 576 - 0605 bcomodels: one (1) year limited parts and labor; (1) year limited doorwarranty. Gdcomodels: two (2) year limited parts and labor; (2) year limited ...