Bakers Pride BCO-G Installation And Operating Instructions Manual - page 3
3
Your oven will be packed sitting on its bottom. The skid may be left under the oven for convenience in
further handling. Unpack carefully, avoiding damage to the Stainless Steel front and/or trim. If
concealed damage is found, follow the instructions detailed in Section A (Receiving). Keep the area
around the ovens free and clear of combustible materials. Do not store anymaterials on top of or under
any oven. The provision for adequate air supply to your oven for ventilation and proper gas combustion
is essential. As a minimum, observe the clearances detailed in Section D (Location). Provide adequate
ventilation and make up air in accordance with local codes. Servicing your oven is done through the
front control panel and right side access cover. Ensure that these areas are kept unobstructed for easy
access.
(1) Tilt Oven over to left-hand side and attach two 31” legs on the right-hand side with three ½” bolts
and washers. Tighten firmly.
(2) Using proper lifting equipment, lift up the left-hand side and attach two 31” legs on the left-hand
side the same way.
(2) Tilt lower unit over to the left-hand side and position two 6” legs on the right side (one for front and
one for back), secure in place by using 4 bolts (3/8”-16) per leg. Tighten firmly.
(3) Using proper lifting equipment, lift up the left side of the unit and attach the other two legs in the
same way.
(4) Using the lifting equipment, raise the top oven to proper height and slide on top of the bottom
oven. Line up sides and front and fasten to each other at the rear of the units by using a mounting
bracket supplied in the stacking kit.
(1) Loosen 12 bolts (attaching 31” legs) slightly.
(2) Remove 4 inner bolts, 1 from each of the 4 legs, place top right angle and top left angle
underneath and tighten these 4 bolts.
(3) Insert “Open Rack Shelf” and tighten into place with eight 3/8-16 screws, washers and nuts.
(4) Position “Rack Supports” and tighten in place using 4 each of flat washers and 5/16-18 Hex Nuts.
For a single unit: Refer to Figure 4
For a stack of two ovens: Refer to Figure 3
To assemble an open rack stand: Refer to Figure 1
(1) Remove flue from bottom oven prior to stacking.Whentopovenisproperlypositioned on bottom
oven, re-install the flue back on the bottom oven.
!
!
CAUTION
Do not store combustible items or materials on racks.
2
3
4
5
6
7
8
9
10
Figure 1
OPEN RACK STAND ASSEMBLY INSTRUCTIONS: BCO-E & GDCO-E
STEP 1)
STEP 2)
STEP 3)
STEP 4)
Attach 4 each Item 2 with 16
each 3/8 -16 bolts to the
threaded holes located in
the bottom of the oven or
supplied with leg kit.
Place Item 4 between the
legs and over Item 9 then
attach Item 9 to Item 4 with
16 each 10-32 screws.
Attach Item 5 to Item 10
using 2 each ¼ -20 screws
(Both sides)
Place Item 5 into Item 6 and
into the holes in Item 4.
(Both sides)