BandLuxe E580 Series Installation Manual - Note
9
Note
If you can NOT connect to the network, please follow below steps to set
APN manually.
1. Go to
Network > Mobile Internet > WWAN Setting- APN Profile Setting
to enter the APN profile name, then click Add.
2. Enter APN, User Name, and Password, then click Save.
3. Go to Network > Mobile Internet > WWAN Setting- Network Setting
to configure the APN to Manual. Then select the Profile Name you
added from the Profile Selection, then click Apply.
Above change will be applied after the system is rebooted.
Once the external SIM is reinserted, you must restart the CPE to read the
SIM card properly.
For more detail information, please go to
http://www.bandrich.com/UM/E580_Embedded_Series.pdf
to download User Manual.
Using web management
Step 1: Enter the IP address (http://192.168.1.1) of the CPE in your
browser’s address bar then press Enter.
Step 2: On the opening screen, enter the username (admin) and password
(admin).
Step 3: Click OK to login to the main screen.
.
Step 4: Click one of the header tabs for advanced features.
E580 series CPE uses network domain 192.168.1. X.
For any downstream connections, all devices should avoid using this
network domain otherwise there might be IP address conflict and cause
communication failure.
If the PIN verification on your SIM card is enabled, please go to
Network > Mobile Internet > UICC/SIM PIN Management to unlock the
PIN code.