BandLuxe E580 Series Installation Manual - Adjusting Cpe Position
Manual is about: (Embedded SIM)
of
14
8
Adjusting CPE position
For optimum reception, fine tune the CPE orientation (horizontally or
vertically) to have the best signal strength shown from LED or other test
equipment.
Note: LEDs (on the front panel) indicate signal strength.
Horizontal angle adjustment
Step 1: Loose the top knob using the wrench as
shown.
Step 2: Swivel the device to the left or right
to face the direction of the base
station.
Step 3: Secure the knob using
the wrench after the
position is fixed.
Vertical angle adjustment
Step 1: Loose the side knob using the wrench as
shown.
Step 2: Adjust the device position up or down
to face the direction of the base
station.
Step 3: Secure the knob using the wrench
after the position is fixed.