BandLuxe E580 Series Installation Manual - Install External Sim Card
2
Install external SIM card
Notice before installation
Step 1: Unscrew the SIM card slot.
Step 2: Insert a valid SIM card into the SIM card
slot. Push it fully until it clicks into place.
Step 3: Screw the cap back on
tightly
.
Once the external SIM is plug in,
the embedded SIM will no longer be activated.
Choose a solid and safe place (Wall or Pole) for CPE installation
Note:
For optimum reception, there are few things you should consider before
installation. Please see Appendix 2 for important installation considerations.
Prepare two Ethernet cables
Prepare wrenches
Prepare adjustable wrenches or four combination wrenches
(size: 13mm x 2, 8mm x 1, and 19mm x 1)
1
3
Be sure that one of the cables used is an outdoor grade CAT 5e (or above)
Ethernet cable type and the length of the cables are adequate to reach the
location of the CPE and indoor PPoE.
Warning:
1. Do NOT start any traffic test (ex: throughput
test and internet browsing) before the
installer returns to the ground.
2. Do ground the CPE to provide protection
from ESD (electrostatic discharges) and lightning.
2
The CPE has Sprint embedded SIM inside.
For special application that you have to use an
external SIM card, please follow below steps to
load the external SIM card.
- Choose the best location of the house and the
orientation of the CPE to get the strongest signal
reception from base station.
- The ambient temperature for E580 series
must be within:
E580A series : -10°C to 55°C
E580P series : -40°C to 55°C
SIM card