Bang & Olufsen BeoSound 5 Encore Manual - page 20
This product is in
conformity with the
provisions of the Directive
1999/5/EC (R&TTE).
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB,
GR, HU, IE, IS, IT, LI, LT, LU, LV, MT, NL, NO, PL, PT,
RO, SE, SI, SK, TR.
Hereby, Bang & Olufsen declares that this Audio
System with WLAN is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC.
The Declaration of Conformity may be consulted
at www.bang-olufsen.com/guides.
This product incorporates copyright protection
technology that is protected by U.S. patents and
other intellectual property rights. Use of this
copy right protection technology must be
authorized by Rovi, and is intended for home and
other limited viewing uses only unless otherwise
authorized by Rovi. Reverse engineering or
disassembly is prohibited.
HDMI, the HDMI logo and High-Definition
Multi media Interface are trademarks or registered
trade marks of HDMI Licensing LLC.
The distance from the human hand to the
transmitter antenna during normal use of this
product will be at least 6 cm, which is more than
the RF exposure safety distance of 4 cm.
Bang & Olufsen cannot vouch for the quality of
net radio stations available from programme
providers.
For the US-market only!
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found
to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harm ful inter ference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or tele vision
reception, which can be determined by turning
the equip ment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
– Consult the retailer or an experienced radio/TV
technician for help.
For the Canadian market only!
This class B digital apparatus meets all require ments
of the Canadian Interference-Causing Equipment
Regulations.
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may
not cause interference, and (2) this device must
accept any interference, including interference
that may cause undesired operation of the device.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce
potential radio interference to other users, the
antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for
successful communication.
This radio transmitter (3775A-SMALLENGINE) has
been approved by Industry Canada to operate
with the antenna types listed below with the
maximum permissible gain and required antenna
impedance for each antenna type indicated.
Antenna types not included in this list, having a
gain greater than the maximum gain indicated for
that type, are strictly prohibited for use with this
device:
Tyco Electronics Antenna 1551359-1, Gain 5dBi,
Impedance 50 Ohm.
This equipment complies with IC RSS-102
radiation exposure limits set forth for an
uncontrolled environment. This equipment should
be installed and operated with a minimum
distance 20 cm between the radiator and your
body.
Please note that high-power radars are allocated
as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and these
radars can cause interference and/or damage to
LE-LAN (License-exempt Local Area Network)
devices.
For the Japanese market only!
Radio Law Enforcement Regulation: Item 19 of
Article 2, Paragraph 1.
対象は日本のみ!
電波法施行規則: 第 2 章の第 19 条、第 1 項。
特定無線設備の技術基準適合証明等に関する規則
Til det norske marked!
Mekaniske og elektroniske komponenter i
produktene slites ved bruk. Det må derfor påregnes
reparasjoner og utskiftning av komponenter
innen for kjøpslovens reklama sjonstid, som må
regnes som vedlikehold av produktene. Slik
vedlikehold gir ikke grunn lag for å rette mangels
krav mot for handler eller leverandør, og må
bekostes av kjøper.
Apparater som er koplet til beskyttelsesjord via
nettplugg og/eller via annet jordtilkoplet utstyr –
og er tilkoplet et koaksialbasert kabelTV nett, kan
forårsake brannfare. For å unngå dette skal det
ved tilkopling av apparater til kabelTV nett
installeres en galvanisk isolator mellom apparatet
og kabelTV nettet.
För den svenska marknaden:
Utrustning som är kopplad till skyddsjord via
jordat vägguttag och/eller via annan utrustning
och samtidigt är kopplad till ett kabelTVnät kan i
vissa fall medföra risk för brand. För att undvika
detta ska vid anslutning av utrustningen till kabel
TVnätet en galvanisk isolator finnas mellan
utrustningen och kabelTVnätet.
20