Banner VE200G1A Quick Start Manual - page 3
8. If you are using a filter: Thread the filter (4) onto the front of the C-mount lens.
9. If you are using a linear polarization filter: Rotate the outer portion of the filter mount to determine the position where glare is reduced
the most, and use the locking thumbscrew to fasten the filter in position.
10.If you are using a lens cover: Thread the lens cover (5) onto the threaded portion of the sensor.
11.Or, if you are using an external light bracket: Attach an external light bracket to the sensor using the provided hardware kit.
NOTE: For optimal imaging, provide adequate dissipation of heat. A good heat conductor, such as aluminum, may be
required.
Mount the Sensor
1. If a bracket is needed, mount the sensor onto the bracket.
2. Mount the sensor (or the sensor and the bracket) to the machine or equipment at the desired location. Do not tighten the mounting
screws at this time.
3. Check the sensor alignment.
4. Tighten the mounting screws to secure the sensor (or the sensor and the bracket) in the aligned position.
Connect the Cables
1 2
3
4
Figure 4. Cable Connections
1. Power, Discrete I/O connection
2. Light connection
3. Ethernet connection
4. Ethernet indicator
1. Connect the Ethernet cable to the sensor (3) and to the computer or Ethernet switch.
2. Connect the power, discrete I/O cable to the sensor (1), and the leads to the appropriate locations. See
Table 1
on page 3 for the
power, discrete I/O connections.
3. Connect the external light cable (optional) to the light connection (2) if the light is powered by the sensor.
CAUTION: Use Appropriate Power
If the light is powered by the sensor, the sensor power source must be 24 V dc. This connection is for Banner lights
only.
Table 1: Power and I/O Pinouts
Pin
Wire Color
Description
Direction
1
White
Discrete I/O #3
Input/Output
2
Brown
12 V dc to 30 V dc
Input
3
Green
I/O output common
Important: For PNP (sourcing) outputs connect pin 3 to +V
dc, for NPN (sinking) outputs connect pin 3 to 0 V dc. The
discrete I/O pins are 1, 5, 8, 10, and 11.
-
4
Yellow
Reserved
-
5
Gray
Discrete I/O #5
Input/Output
6
Pink
Trigger input
Input
7
Blue
Common
Input
8
Red
Discrete I/O #2
Input/Output
9
Orange
I/O input common
Important: For PNP (sourcing) inputs connect pin 9 to 0 V dc,
for NPN (sinking) inputs connect pin 9 to +V dc. The discrete
I/O pins are 1, 5, 6, 8, 10, and 11.
-
10
Light Blue
Discrete I/O #4
Input/Output
11
Black
Discrete I/O #1
Input/Output
12
Violet
Reserved
-
Shield
Bare metal
Chassis ground
-
VE Series Smart Camera
P/N 191667 Rev. C
www.bannerengineering.com - Tel: +1-763-544-3164
3