Bar aid 400 Installation And Operation Instruction Manual - Operation
10
1618-A-01-09
dE
GB
F
nl
sElEct pRoGRam:
The machine is operating automatically with standard cycle time.
If needed, it is possible to select the shorter program.
To show the present program, push the program button
➃
before
starting the wash cycle.
To change the program, push the program button again.
p01 = Short cycle
(for light / medium soiled glasses)
p02 = Standard cycle (for medium / heavy soiled glasses)
The machine continues with the chosen cycle time until it is switched
off or another program is chosen.
–
opERatIon
Press and hold (3 seconds) the program button
➃
until the actual
temperatures (°c) are displayed (top = rinse, bottom = wash).
The indicators go out 10 seconds after releasing the program button.
Permanent temperature display can be activated on request by the
service technician.
–
–
6 pREVIEw oF tEmpERatuREs
only for machines with optional built-in softener.
When the salt indicator
➇
illuminates, the softener has to be filled with
regeneration salt.
Wait until the wash program is finished.
Open the door.
Unscrew the softener lid and fill the softener with 1.5 kg of "Granular
regeneration salt" (do not use salt tablets).
clean seal and rim of softener lid carefully, before closing the lid.
Close lid and tighten.
In order to prevent corrosion it is necessary to remove any
salt residues from tank bottom.
There will be a slight delay before salt indicator light
➇
extinguishes
after refill.
–
–
–
–
–
–
–
7 REFIllInG thE soFtEnER wIth salt