Bar aid 400 Installation And Operation Instruction Manual - 9 Settings
1
1618-A-01-09
dE
GB
F
nl
attEntIon:
the machine has to be switched off.
open the door.
Push program button
➃
and drain button
➂
simultaneously until the
upper display
➅
shows "boF".
If no button is pressed for 10 seconds, the indicator automatically
switches off and the new settings will be saved.
9.1 adjustmEnt oF dEtERGEnt dosaGE quantIty
Push program button
➃
again.
In the upper display
➅
appears"ch1".
In the lower display
➄
appears e.g.:
"09" = pre-adjusted value of the detergent dosage time =
9 seconds ≈ 2.5 g/l.
To adjust the detergent dosage time, push start button
➁
repeatedly,
until the desired value (0-50 s ≈ 0-14 g/l) appears.
Adjustment should be done in accordance with chemical suppliers
recommendations.
9.2 adjustmEnt oF RInsE aId dosaGE quantIty
Push program button
➃
again.
In the upper display
➅
appears "ch2".
In the lower display
➄
appears e.g.:
"10" = pre-adjusted value of the rinse aid dosage time =
10 seconds ≈ 0.35 g/l.
To adjust the rinse aid dosage time, push start button
➁
repeatedly,
until the desired value (0-50 s ≈ 0-1.8 g/l) appears.
Adjustment should be done in accordance with chemical suppliers
recommendations.
9.3 adjustmEnt oF watER haRdnEss
with optional softener only.
To adjust the softener to the local water hardness (obtain details from
local water authority):
Push program button
➃
again.
In the upper display
➅
appears "h02".
Push start button
➁
repeatedly, until the required value (h01-h03)
will be displayed.
h01 = up to 12 °eh / h02 = 13 to 25 °eh / h03 = 26 to 37 °eh
water hardness (°eh = Clark).
–
–
–
–
–
–
–
–
–