Bar aid 400 Installation And Operation Instruction Manual - 5 Operation
1618-A-01-09
9
dE
GB
F
nl
5.1 pREpaRatIon
Check correct position of wash arms and strainers.
You should be able to turn the wash arms easily by hand. If not, clean
the wash arms as described in chapter 8.
open shut-off valve.
switch on main switch or put the plug in.
Check level of detergent and rinse aid containers.
Close door and push the on button
➀
, tank will be filled.
The start button flashes green during fill and heating cycle.
This process can take several minutes.
When the button changes to green steady burning light, machine is
ready for operation.
5.2 Run
First remove lemon peels, tooth-picks, olive pips, paper etc.
Then place glasses face downwards into the rack.
Put rack into the machine and close the door.
Push the start button
➁
.
During the wash cycle is running, the button flashes green.
machines with built-in softener:
If during regeneration* a program has been started, cycle time is
extending up to 4 minutes.
* Indicated by a moving light point at the rinse temperature display.
As soon as the start button
➀
changes to steady green light, the
wash cycle is finished.
Open the door and take out rack.
Allow glasses to dry for 1 minute approx.
–
–
–
–
–
–
–
–
–
–
–