Barco CINE 6 Installation Manual - Installation Set Up
Installation Set Up
R5975819.05 BARCO CINE 6 21112002 ____________________________________________________________________________ 4-1
INSTALLATION SET UP
Access to Controls
Opening procedure
During the projector set up and installation it is necessary to remove the side and top covers.
First remove the top cover, covering the lenses :
•
Turn both lock screws counter clockwise until they are raised by the springs.
•
Lift up the cover and remove.
To remove the second top cover, covering the electronics, first the side covers have to be removed.
Removing the side covers :
•
Turn out the two black screws on the bottom of the side covers.
•
Tilt the side cover and lift it up.
•
Repeat the same for the other side cover.
Removing the second top cover :
•
Loosen the four M4 screws.
•
Slide the cover a few to the back and lift up.
4