Barco CINE 6 Installation Manual - G2 Adjustment
G2 Adjustment
R5975819.05 BARCO CINE 6 21112002 ____________________________________________________________________________ A-1
G2 ADJUSTMENT
G2 adjustment
Enter the adjustment mode by pressing ADJUST and highlight SERVICE. Press ENTER to start up the service mode.
Highlight 'common settings' and press ENTER.
ENTER starts up the common settings menu.
EXIT returns to the adjustment mode menu.
Highlight G2 adjust and press ENTER.
A safety notice will be displayed to warn the operator.
If you are qualified, press ENTER to continue with the G2 adjustment, otherwise press EXIT to return to the service menu.
If ENTER is pressed, the G2 menu will be displayed.
Open the top cover to reach the G2 controls and adjust these G2 controls for red, blue and green separately.
Look to the projected image and observe the raster behind the image while the ABL function is ON.
Switch the ABL to OFF by pressing ENTER and adjust the G2 control until the raster brightness looks the same as when the
ABL function is ON.
Check the correct raster adjustment by pressing ENTER to toggle ABL to ON. Repeat these steps if necessary.
Continue with the other colors. Use the right or left arrow key to select the next color.
Note : The best result is obtained in a completely dark room or by looking into the lenses, but be aware that
brightness and contrast are on a high level.
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 1
Select with or
then
A
SAFETY
NOTICE
RISK OF ELECTRICAL SHOCK
G2 ADJUSTMENT SHOULD BE
PERFORMED ONLY BY
QUALIFIED INSTALLATION OR
SERVICE PERSONNEL.
AS USER OR OPERATOR :
PRESS
AS QUALIFIED PERSONNEL
PRESS
Select color with or
G2 ADJUSTMENT
RED
ABL : ON
Select with or
then
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with or
then
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
CRT DRIVE MODE
MEMORY BANKS : off / on