Barco CINE 6 Installation Manual - page 18
Installation Set Up
4-4 ____________________________________________________________________________ R5975819.05 BARCO CINE 6 21112002
Follow next procedure to check the configuration :
- switch on the projector.
- the projector starts up on the last selected source.
- press the ADJUST key.
- highlight 'SERVICE' with the control disc and press ENTER. The 'SERVICE MODE' will be displayed
- select with the control disc 'PROJECTOR SET UP' and press ENTER. The 'PROJECTOR SET UP' will be displayed.
- Select with the control disc 'IDENTIFICATION' and press ENTER.
The projector displays the Identification screen
This screen gives information about the projector configuration in the subject 'config.'.
MAIN MENU
Image Control
Function Keys
Service Menus
Select with or
then
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 1
Select with or
then
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with or
then
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
COMMON ADDRESS : 0
BARCO LOGO
Select with or
then
CINE 6
Proj. address
: 001
Soft. Version
: 6.00
Config.
: Ceiling
Front
Baudrate PC
: 9600
Text
: ON
Serial No.
: 103589552