Barco CINE 6 Installation Manual - Power Connection

Power Connection

R5975819.05  BARCO CINE 6 21112002 ____________________________________________________________________________ 6-1

POWER CONNECTION

Power (mains) cord connection

Use the supplied power cord to connect your projector to the wall outlet.  Plug the female power connector into the male connector

at the front of the projector.

Input power (mains) voltage adaptation

Attention

The  BARCO CINE 6 -  R9002372 leaves the factory with a PFC module to operate on a mains (power) input from 110Vac to 230Vac.

6

Stand By / Operational

Pause

Sync

Hold Down EHT

IR

120 / 230 V

4 A / 2.5 A

60 / 50 Hz

300 W

Fuses

Warning :

For continued protection against fire hazard :

- replace with the same type of fuse

- refer replacement to qualified service personnel

Fuse type : 2 x T5A/250V  (Barco order number : R314104)

Switching on/off

The projector is switched ON and OFF using the power (mains) switch ON/OFF.

Pressed

: ON

Not  pressed : OFF

The projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode' (see projector set up)

Stand by indication lamp :

Green : projector in operational mode

Red

: projector is in stand by.