Barco PreCa 1280i Networking Manual - page 5
5
560425 BARCO network (E)
5
Enter the IP address.
1
Left-click on the leftmost IP Address box.
2
Left-click on the numeric keys on the lower area
of the display.
Enter three digits of the IP address. For a single-
digit or two-digit number, first type 0 or 00.
The cursor moves to the next box. Repeat the
same operation.
6
Enter the Subnet Mask.
1
Left-click on the leftmost SubNet Mask box.
2
Left-click on the numeric keys in the lower area
of the display.
Enter three digits of the Subnet Mask. For a
single-digit or two-digit number, first type 0 or 00.
The cursor moves to the next box. Repeat the
same operation.
7
Register the settings.
Left-click on “Save.”
8
Clear the menu.
Left-click on “Return to Window.”
9
Turn off the power, then turn it
on again.
Notes:
• For details on the IP Address and SubNet Mask, ask the
administrator of your network.
• If any item other than the IP Address and SubNet Mask
must be set, perform the setting before step 7.
• Be sure to reboot this unit any time after setting/changing
the IP address.
Setting items
L
Enable NetWork
To enable/disable the network function
L
Read Only (FTP, WEB: disable Write/Control)
If operating the unit from a PC, remove the check
mark ( ).
L
Internal Server
To set the IP address, subnet mask, user ID, and
password for the FTP, HTTP, and Telnet servers
of this unit.
When you set “User ID” to other than “anonymous,”
a certification will be requested before connecting
to the network. You can log on using the user ID
and password specified here.
L
Enable FTP Client
To enable/disable the function to send data to a file
server. When the function is disabled, the menu
button becomes invalid, preventing erroneous op-
eration.
L
External Server
To set an external FTP server. This item must be
set if you want to send an image file to the FTP
server. For FTP servers, ask the administrator of
your network.
**BARCO network(E)
2001.1.16, 2:15 PM
5