Barco PreCa 1280i Networking Manual - page 7
7
560425 BARCO network (E)
7
Enter the IP address of this unit
in the “Exceptions” field.
Left-click in the “Exceptions” field, and type the IP
address of this unit specified in step 5 on page 5.
• Enter a dot (period) between each three digits.
• If the three digits begin with “0” or “00,” skip “0”
input (s).
8
Select “OK.”
Left-click on “OK.”
Repeat this operation until the display in step 1 is
restored.
When using Netscape
Communicator 4.5
To control this unit using Netscape Communicator 4.5 as
your Web browser, perform the following settings:
Attention:
• Some special settings may be required for your
network. Please consult the administrator of your
network before starting to make the settings, to
eliminate causing any trouble in networking.
1
Start your PC.
For details, refer to the instructions for the PC.
2
Run Netscape Communicator.
For details, refer to the instructions for the PC or
Netscape Communicator.
3
Choose “Preferences” from the
“Edit” menu.
Left-click on “Edit,” and a pop-up menu is displayed
beneath. Then left-click on “Preferences.”
Continue
Left-clicking here displays a
pop-up menu.
Enter the address in this field.
Example: when the address is
192.168.1.2
**BARCO network(E)
2001.1.16, 2:15 PM
7