Barco R9002240 Installation Manual - page 14
Installation set-up
4-2
5975698 BARCOVISION 1609s 220198
Scan Adaptation
The scan switches must be placed in the correct position which corresponds to the desired scanning configuration.
To change the scanning, it is necessary to remove the projector top cover and to open the protection plate.
For opening the projector's top cover, see 'Access to controls'.
WARNING !
TURN OFF PROJECTOR AND UNPLUG THE POWER
CORD BEFORE CHANGING THE SCAN DIRECTION.
Open the top cover and remove it from the
projector (see p.4-1);
Loosen the 3 lock screws;
Remove the 3 retaining screws on each
side of the cover plate;
Remove the fixation screw nearby the
fan;
Open the protection plate and pivot it for-
ward (toward lenses).
Gaining access to the scan switches
Lock screws
Fixation screw