Barco R9002240 Installation Manual - page 18

Projector set-up

5-2

5975698 BARCOVISION 1609s 220198

Addressable with RCU

Addressable with PC, MAC

or workstation

Setting the projector address

The projector's address may be set to any value between 0 and 255.

When the address is set, the projector can be controlled now by  :

*

the RCU for addresses between 0 and 9.

*

a IBM PC (or compatible) or Apple MAC for addresses between 0

and 255.

1

128

2

64

3

32

4

16

5

8

6

4

7

2

8

1

Setting the address is a hardware SET-UP of your projector which

must be done during installation. Use the 8 DIP switches provided on

the controller board labelled 'Projector Address'.

Each DIP switch has its own decimal value. The sum of the values

associated to those DIP switches gives the address. As shown in

the table, if Switch No. 1 is set to ON, it represents a decimal value

of 128, Switch No.2 for 64, Switch No.3 for 32, and so forth.

In the given example,  the projector address is set to 202 :

DIP switch No.

: 1  2  3  4  5  6  7  8

Position ON/OFF : 1  1  0  0  1  0  1  0

Sum : 1x128 + 1x64 + 0x32 + 0x16 + 1x8 + 0x4 + 1x2 + 0x1 = 202

Factory preset address = 0

Note :

When the address button on the RCU is pressed, the projector will

display its own address on the screen.  Once the address button is

pressed, to continue using your RCU, it is necessary to enter an

address, even when the displayed address is correct. Use the

numeric keys to enter the address.

For more information, please refer to the Owner's Manual of this

projector.

21

2))

Switch  No

Value

PROJECTOR 

ADDRESS

001