Barco Vision 708 9002357 Installation Manual - page 20
Power Connection
6-2
5976026A BARCOVISION 708 200499
- Loosen both screws of the protective cover and take off the cover.
- Pull out the 'power selector plug' and re-insert it as illustrated,
depending on the wall outlet in the room.
- Re-mount the protective cover and secure with both screws.
- Re-insert the module.
- Fasten the front panel with the 2 retaining screws.
Fuses
Warning
For continued protection against fire hazard :
- replace with the same type of fuse
- refer replacement to qualified service personnel
Fuse type : 2 x T5A/250V (Barco order number : R314104)
Switching on/off
The projector is switched ON and OFF using the power (mains)
switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image dis-
played) or in the 'stand by mode', depending on the setting of the
power up mode in the projector set-up menu in the service mode.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
-9V
SF
HOLD
DOWN
EHT
STANDBY
-CONV
-17V
+17V
+HTHD
+CONV
+9V
+210V
+30V
123
123
123
COINC
HOLD
DOWN
H
D
Leds on the front plate of the projector
9
9