Barco Vision 708 9002357 Installation Manual - page 32
G2 Adjustment
A-2
5976026A BARCOVISION 708 200499
Open the top cover to reach the G2 controls and adjust these G2
controls for red, blue and green separatly.
The controller automatically increases brightness and contrast until
the raster behind the displayed text becomes visible.
Look to the projected image and observe the raster behind the image
while the ABL function is ON.
Switch ABL to OFF by pressing ENTER and adjust the G2 control until
the raster brightness looks the same as when the ABL function is ON.
Check the correct raster adjustment by pressing ENTER to toggle ABL
to ON. Repeat these steps if necessary.
Continue wiht the other colors. Use the right or left arrow to select
the next color.
Note : The best result is obtained in a completly dark room or by looking
into the lenses, but be aware that brightness and contrast are on a
high level.
G2 Adjustments
Red Green Blue
Loosen screws and move the cover plate
to the left to access the G2 controls.
Cover the G2 controls again after alignment.