BARIX Annuncicom IC User manual - page 23
Annuncicom IC User Manual Version 01.20
Page
22
9.2 Door station and control station
Situation: one door and one control station. A visitor can
push the RING button to activate the buzzer on the
control station. Pushing the TALK button on the control
station permits to talk to the door station. When
releasing the TALK button the visitor can talk for a
predefined time.
Pushing the DOOR button on the control station will
activate the door strike to let the visitor in.
Door station
192.168.0.10
Intercom
Panel with
one button
Door strike
Intercom
Panel with
two buttons
Control station
192.168.0.20
LAN
Flash or
buzzer
9.2.1 Door station configuration
Wiring
The door station is connected to an intercom panel:
Speaker to speaker out (C).
Microphone to Microphone In (E or F).
The RING button to Input 1 (B2 and B3).
The door strike to Relay normally open (B4) and Relay
common (B5).
Network settings
SonicIP is disabled; no need to hear it on power up as the
IP Address is static and known and the device will stay
powered most of the time.
Audio settings
Change the Input source to "Mic".
The Microphone Gain might need adjustment later on
depending on the used microphone.
Same goes for Volume depending on the speaker.
Quality and Sampling frequency settings can be increased to
the lower the playback delay but this will increase network
traffic slightly.
Streaming settings
The door station is set to auto answer for 12 seconds
(Post Trigger Play) using UDP broadcast.
When receiving a stream, 4096 Bytes will be buffered first
before playing it back over the speaker. Lower this value to
minimize delay, increase this value to prevent dropouts.
The stream will be transmitted using a UDP broadcast on
port 3030.