BARIX Annuncicom IC User manual - page 7
Annuncicom IC User Manual Version 01.20
Page
6
6.2 Status and control
Status
Shows the current status.("INACTIVE", "TALKING",
"TALKING SUPPRESSED", "FORCED TALKING" and
"LISTENING"). The button nearby refreshes the status
information.
Input peak value
The number [0..32767] shows the peak value of the device
input (Line in or Mic In).
Output peak value
The number [0..32767] shows the normalized peak value of
the encoder when encoding (e.g. Talk) or the the
normalized peak value of the decoder when decoding (e.g.
Listen).
TALKING
Click the "FORCE" link to force the talking (not visible on
"send always"
). This overrides the "TALKING
SUPPRESSED" mode, e.g. when an other device is talking to
this device.
Click the "TALK" link to start talking (not visible on
"send
always"
).
Click the "STOP" link to stop talking (not visible on
"send
always"
).
The indication next to TALKING has the following
meaning:
GREY: not talking, GREEN: talking, RED: forced talking
ENTRY
Select "All" for talking to all configured entries (targets) in
the active table. To talk to a specific entry (target) click on
the respective number.
TABLE
Click on the respective number to select a table.
BUTTON 0 and 1
Click the "SET" link to simulate the button beeing pushed.
Click the "CLR" link to simulate the button beeing released.
The indication next to "BUTTON" has the following
meaning:
GREY: released, GREEN: pushed (simulation is not shown!)
RELAY
Click the "TOGGLE" link to activate the relay for the
"Relay toggle duration" time, adjustable in "Settings" under
"I/O".
Click the "SET" link to activate the relay.
Click the "CLR" link to deactivate the relay.
The value next to "RELAY" has the following meaning:
GREY for inactivated, GREEN for activated
CTS IN (RS-232)
Click the "SET" link to simulate CTS beeing activated.
Click the "CLR" link to simulate CTS beeing deactivated.
The indication next to "CTS IN" has the following meaning:
GREY: inactiv, GREEN: activ (simulation is not shown!)
RTS OUT (RS-232)
Click the "SET" link to activate RTS.
Click the "CLR" link to deactivate RTS.
The indication next to "RTS OUT" has the following
meaning:
GREY: inactiv, GREEN: activ
Tips
- To configure the device click on the
"CONFIGURATION" button.
- The white triangle next to the Annuncicom IC logo as
well as the "+" (above) and the "-" sign (below) can be used
to change the volume temporarely.
- This page can be customized to meet installation
requirements. Download the developement kit from
www.barix.com .