BARIX Annuncicom IC User manual - page 5
Annuncicom IC User Manual Version 01.20
Page
4
5 Installation
Once the Annuncicom IC is connected to your network, it
will automatically receive an IP address from your
DHCP
server (Internet gateways run usually a DHCP server).
If no DHCP server can be reached, our
IPzator
function
will search the network for a free IP address.
The Annuncicom IC will announce the IP address using
SonicIP
technology.
5.1 Connecting the Annuncicom IC to
your audio equipment
Connection to audio equipment is possible by offering two
different audio output options:
For connection to an amplifier, the Annuncicom IC features
a mono RCA output ( H ) . Simply connect the included
stereo RCA cable ( d ) to the audio input on your amplifier
using the red plugs on each side.
For connection to a speaker, the Annuncicom IC features a
speaker output ( C ) . Connect the wires into the 2-pin
spring terminal connector (e) and plug it in.
Connecting audio sources is possible by offering two
different audio input options:
For connection to an audio source, the Annuncicom IC
features a mono RCA input ( G ) . Simply connect the
included stereo RCA cable ( d ) to your audio output using
the white plugs on each side.
For connecting a microphone, the Annuncicom IC features
two microphone inputs ( E + F ) . Connect the wires into the
3-pin spring terminal connector (e) and plug it into input E
or plug in the microphone directly into input F.
5.2 Connecting the Annuncicom IC to
your power supply
Connection to power supply is possible by offering two
different options:
To connect the included power supply, the Annuncicom IC
features the power connector ( I ) . Plug the power supply
(b) into the
power jack ( I ) of the Annuncicom IC and the
other end into the power outlet of the wall.
To connect to an existing 9 to 24 Volt DC power supply,
the Annuncicom IC features the power connector ( D ) .
Connect the wires into the 2-pin spring terminal connector
(e) and plug it in.
5.3 Connecting the Annuncicom IC to
your network
STEP 1
Plug the included network cable ( g ) into the network port
of the Annuncicom IC ( A ) and the other end into your
hub or switch.
STEP 2
Plug the included earphone ( c ) into the RCA output ( H )
and put it in your ear.
Get the pen and paper ready to write down the IP address
that will be announced in step 5.
The announcement of the IP address is called
SonicIP
.
STEP 3
Plug the power supply (b) into the
power jack ( I ) of the
Annuncicom IC and the other end into the power outlet of
the wall.
NOTE
When power cycling the Annuncicom IC we recommend
to disconnect/connect the power supply at the wall socket.
To prevent electrical overload of the device the power
supply should only be plugged into the wall socket with the
power supply connected to the Annuncicom IC first.
STEP 4
The Annuncicom IC will now search for a
DHCP
server
to get an IP address and announce this address over
the earphone.
Example: 192.168.0.12 (Voice: one nine two dot …)
Make sure you write this IP address down. If no
DHCP
server is found then our
IPzator
function will search the
network for a free IP address (this could take up to 5
minutes).
NOTE
Your Annuncicom IC is now ready to start working, we
recommend, however, that you set a
Static IP
address so
that the IP address will not change every time you power
up the Annuncicom IC.
See section 8.1 how to set a Static IP.