Bass BALL Owner's Manual - page 10
BALL
– Floating Wireless Sound System
2012_V2 Page 10 von 14
6
Batterie Low Indication and Auto-Shut-Off of Speaker
Speaker
The Speaker is designed with an energy saving feature.
At wireless receiving mode:
In the case of turning off the Transmitter or no signal is received from the Speaker, where the wireless
indicator
on display will blink. Around four minutes later, the Speaker will shut-off automatically.
In FM radio, SD/USB and Wireless receiving modes:
Wh
en battery level in the Speaker is low, “low-battery” indicator
displays and the unit will shut-off
as well.
You may replace the battery with fresh one.
Transmitter
When battery level in the Transmitter is low, the Tx Status LED indicator will blink alternately in Red
and Green light.
Replace the old battery with fresh one.
7
Radio Tuner Operation
Radio Tuning
1. Press the POWER button to turn on the unit.
3. Press the Fn (function) button to select FM radio receiving mode.
4. To manually tune to a desired station, repeatedly press the TUN
+/-
button.
5. To automatically search for stations with strong signals, press and hold the TUN
+/-
button until the
frequency digits on display begins to scan then release the button. The tuner will stop on the first
strong signal it finds.
- Manual tune to select weaker stations that might be skipped during automatic tuning.
- If the automatic tuning does not stop on the exact frequency of the station, for example, it stops
on 88.9 MHz instead of 88.8 MHz, use the manual tuning method to "fine tune" to the exact
frequency of the desired station.
- You may also press the ST/MO button to select FM stereo or mono receiving mode, if
necessary.
Radio Preset Stations
The unit allows you to store up to 20 FM stations for easy recall at any time.
Preset Stations
1. Press the POWER button to turn on the unit.
2. Press the Fn button to select FM radio receiving mode.
3. Tune to the radio station you want to store in memory by pressing the TUN +/- button.
4. Press the MEM button. The preset channel number appears on display and blinks.
5. To select desired preset station number, press the CH
+/-
button.
6. To confirm preset location, press the MEM button.
7. Repeat steps 3 to 6 to store other stations, if apply.
1. There is a few seconds delay when programming, after this delay time, the unit will automatically
switch back to normal tuner mode.
2. You can overwrite a preset station by overwriting and storing the new frequency in its place.
Recalling Preset Station
1. Press the POWER button to turn on the unit.
2. Press the Fn button to select FM radio receiving mode.
ADVICE
ADVICE