Bass BALL Owner's Manual - page 7
BALL
– Floating Wireless Sound System
2012_V2 Page 7 von 14
16. Lower housing
17. Battery cover
18. Battery cover lock
19. Clock battery compartment slot
20. Battery Compartment
21. RESET button ---- Reset the unit
22. DC IN jack ---- For the connection of external DC power supply
23. Battery Type Switch
24. SD/MMC card slot
25. USB connector
4
Installation
4.1.1
Batterie Installation:
Transmitter
A battery compartment located at bottom of the transmitter.
(1) Open the battery compartment lid.
(2) Follow the polarity diagram shown inside the compartment and install 3
x AA (UM-3) batteries.
(3) Close the compartment lid.
Speaker
A battery compartment located at the inner cabinet of the speaker unit.
(1) Wipe the unit with soft cloth to remove any water drop, if the unit has been played in water.
(2) To open the unit, grip the lower housing and turn it counterclockwise.
(3) Release the inner battery cover lock and open it.
Clock setting battery back-up
(4) For clock setting backup, follow the polarity diagram shown inside the compartment and install a
CR2032 lithium battery into the clock back-up battery slot. If the unit is at the first time usage, just re-
move the plastic insulation tag from the battery slot (battery included).
Main Battery, for radio, SD/USB and wireless receiving operation
(5) The unit allows regular alkaline type or rechargeable type battery to operate.
Install rechargeable battery
Follow the polarity diagram shown inside the compartment and install 6 x AA (UM-3) type rechargea-
ble batteries (not included). The Battery type switch must slide to RECHARGE ON position.
Install alkaline battery
Follow the polarity diagram shown inside the compartment and install 6 x AA (UM-3) Alkaline type bat-
teries (not included). The Battery type switch must slide to RECHARGE OFF position.
Switch to "RECHARGE ON" position to charge the rechargeable battery.
Switch to "RECHARGE OFF" position when normal type (e.g. alkaline type) battery is used.
ADVICE