Bass BALL Owner's Manual - page 9
BALL
– Floating Wireless Sound System
2012_V2 Page 9 von 14
This set-up is for charging the rechargeable battery of the Speaker unit only.
Do not operate the Speaker with this set-up near Water and Moisture environment.
5
Listening to Wireless Audio Source
Transmitter
1. Raise the Audio player cover.
2. Pull out the AUX-in cable and connect the 3.5mm stereo plug to line-out jack or headphone jack of
your external audio device.
3. Turn on the external audio device.
4. Press the AUX-in cable retrieve button located at the back of the transmitter and retrieve the AUX-in
cable to a desired length, if necessary.
5. Place your audio device on the Audio player platform then close the Audio player cover.
6. To turn on the transmitter, slide the POWER switch to ON position. The Tx (transmit) Status LED
indicator will turn on and change to Green colour which indicates that signal is transmitting.
If the Tx Status LED indicator remains in Red colour, try to increase the volume level of your external
audio device. Once sufficient audio level is detected and the Tx Status LED indicator will change to
Green colour.
Speaker (receiver)
7. Press the POWER button turning on the Speaker.
8. Press the Fn (function) button to select the wireless receiving mode, the wireless indicator
blinks on display.
9. Once it received the signal and the wireless indicator
will display steadily.
10. Now you may press the VOL +/- button and adjust the volume to a desired level.
Secondary Aux-In
At rear of the Transmitter, Left and Right RCA type stereo jacks are available for the connection of
secondary audio signal source. Instead of using the built-in AUX-in cable, you may connect an exter-
nal
audio device to the Transmitter by using a RCA type audio cable.
1. Connect an external audio device to the Transmitter by using a RCA type audio cable.
2. On the front of the Transmitter, unplug the 3.5mm stereo plug of the built-in audio cable from any
external audio device, if apply.
If both front (Aux-in cable) and rear (RCA input jack) are presented with audio signals, where both
signals will be broadcasted.
3. Turn on the external audio device.
4. Follow the steps 6 to 10 in the above “Listening to Wireless Audio Source “section.
Frequency Scanning
The system provides three frequency channels for your selection.
In case there is interference on current operating channel, you may implement following steps to ob-
tain
the best reception.
1. From the Channel Selector of the Transmitter, select other channel.
2. From the Speaker, press the SCAN button and the unit will match with the new channel
automatically.
CAUTION
ADVICE
ADVICE