Baudoulin 6 M26.2 Operating And Maintenance Manual - 200 - Starting The Engine
- 2/4 -
00373 - Edition 01 - September 1
1
Engine operation
C
200 - Starting the engine
Non-contractual
illustrations
Engine with manual pre-greasing pump
b
Check that the 3-way valve is in "
pre-greasing" position
as indicated below.
b
Pre-grease the engine using the manual oil draining pump,
with the engine switched off.
DT 11.G04
DT 11.G06
b
Make sure the drive components are disengaged in Neutral
position.
b
Check that the acceleration control is in "
Idle" position.
b
Start the engine with the fi ring key in "
Start" position on the
control panel (see
DT 11.G04) or via the cabinet of the
machine room (see option
DT 11.G06), press the "START"
push button it the "
Start" switch is in "ON" position.
b
Once the engine has started, the speed stabilises at
700 rpm.
Never exceed an engine speed of 1,000rpm until engine
water temperature reaches 60°C.
Sump pump
Oil change
Pre-greasing