BionX D-Series User Manual - page 12
22
23
Turn on backlight and bicycle light (if applicable)
Push and hold key for 4 seconds - display backlight
and bicycle light (if available, battery integrated) are
turned on.
Turn off backlight
Push and hold key again for 4 seconds.
Select the cycling computer functions
Briefly push the
key to change between:
Trip Distance
DIST
Odometer
ODO
Clock
CLOCK
Average Speed
AVSPD
Chronometer
CHRONO
To reset the cycle computer functions
Hold the
key for a few seconds to reset the distance,
chronometer, or average speed values to zero.
4s
WARNING
If this symbol
appears please contact your BionX dealer for service.
Mountain Mode (where available)
Hold the button from any level of (A) or (G) to
engage. The four assist levels will flash, MOUNTAIN
will appear briefly. Press to disengage.
1
2
3
4
Operating the G2 Throttle
Throttle engagement:
Default min. 3km/h to engage throttle
Note: throttle control is variable, and the force
gauge on the console reacts proportionally. The
throttle function and assist modes are
independent to each other.
Assistance levels 1-4:
From
press for more assist
or for less assist
Generation 1-4:
From
press for more resistance
or for less resistance
NOTE
The G2 throttle is only compatible with the G2 console, and may not be available in all
jurisdictions. Check with your local BionX dealer for local legislation and/or availability.
G1 Console
For the G1 console, substitute mode for power, and
crono for cycle. The assistance toggle remains the same.
G1
G2
Mode/Power becomes Power
Crono becomes Cycle
Remains the same
Remains the same
If you require more information on the G1 console,
please contact your dealer.
english
english