BullFrog Spas Owner's Manual - page 15
PREMIER CONTROL SYSTEM
Note: The pump responsible for heating and filtration (pump 1 low-speed) will be referred to simply as the
pump.
Timeouts refer to a preset length of time that a function is programmed to operate before shutting off
automatically. Certain conditions (filters or freeze) can cause a function to operate longer, while faults
can cause a function to operate for a shorter length of time. The system keeps track of timeouts
regardless of other conditions.
In multi-button sequences, if buttons are pressed too quickly they may not register.
Initial Start-Up
When your spa is first actuated, it will begin the Priming mode. The Priming mode will last for up to 4
minutes, and then it will begin to heat. The water temperature will be maintained during the Standard
mode. You can exit the Priming mode early by pressing WARMER or COOLER.
Icon Legend
1. Setting the Time
Once the spa has been properly connected, notice the
“Time” icon appearing on the screen.
Press
Then
Select the hour by pressing
Or
(Each press changes the time by 1 hour)
Select minutes by pressing
Or
(Each press changes the time by 1 minute)
Press
Press
to exit the time setting procedure
and enter the optional filter cycle
programming.
to exit programming.
2. Optional Filter Cycle Programming
You are not required to set filter cycles; however, it is
an option available to you. To change the filter cycle
settings: Press “Time” “Mode/Prog” “Mode/Prog” “Mode/
Prog” within 3 seconds. You will see the “PROGRAM,”
“FILTER 1” and “START TIME” icons appear on the dis-
play. Press “Warmer” or “Cooler” to choose the filter
start time hour. Enter the hour by pressing “Mode/
Prog” . Press “Warmer” or “Cooler” to choose the filter
start time minutes. Each press changes the start time by
5 minutes. Enter the minutes by pressing “Mode/Prog.”
Press “Mode/Prog” to see the “PROGRAM,” “FILTER 1”
and “END TIME” icons. Adjust the time as done above.
Press “Mode/Prog” to see the “PROGRAM,” “FILTER 2”
and “START TIME” icons. Proceed as above.
Press “Mode/Prog” to see “PROGRAM,” “FILTER 2” and
“END TIME” icons. Adjust the time as done above.
Pressing “Mode/Prog” will enter the new filter cycle
times into the system and display the current water
temperature.
Pressing “Time” at any time during this programming
sequence will save the values entered up to that point
and exit programming.
Bullfrog Spas Owner’s Manual
15