BullFrog Spas Owner's Manual - page 29
SPA SHELL CARE
Aristech® Spa Surfaces
For normal cleaning, use Ivory® liquid dishwashing soap or its equivalent. For stubborn stains, use Spic
& Span® in powder form or its equivalent. To apply these cleaners, use a soft, damp cloth or sponge.
Rinse well and dry with a clean cloth.
General Cleaning
With normal use of the spa, oils, lotions, and hairspray will build up on the surface of the water. This will
leave a scum line around the perimeter; it can be easily removed using Surface Cleaner or its equivalent.
To remove grease, oil, paint, or ink stains use 25% isopropyl alcohol in water.
To clean hard water stains, remove light scratches and/or protect your spa shell, contact your authorized
Bullfrog Portable Spa dealer. Note: Never allow your spa surface to be exposed to acetone (nail polish
remover), nail polish, dry cleaning solution, lacquer thinners, gasoline, pine oil, abrasive cleaners, or any
other harsh chemical. These chemicals can void the warranty. Avoid using cleaning agents that leave
suds in the water. Be sure to clean the JetPaks and the JetPods twice a year.
SPA CABINET CARE
The Eternawood cabinet components are made to provide many years of maintenance free service. For
normal cleaning, use Ivory® liquid dishwashing soap or its equivalent. For stubborn stains, contact your
authorized Bullfrog Portable Spa dealer.
SPA COVER CARE
Your spa cover is warranted by its manufacturer, Sunstar Enterprises, 127 No. Las Posas, San Marcs,
CA 92069 (Phone: 760-744-2172). Although basic instructions are provided below, it is important that
you refer to the Sunstar information that came with the cover. Sunstar provides detailed information on
caring for your spa cover and what to do to protect its warranty.
On a monthly basis, complete the following:
1. Remove the cover and lay it down on a flat, clean surface near a garden hose.
2. Rinse the cover to remove any loose debris.
3. Clean the top (vinyl) of the cover with a mild solution of dishwashing soap and a soft bristle brush.
Using a gentle circular motion, scrub the cover, careful to not let any of the cover dry before rinsing
with water.
4. Rinse the cover thoroughly and dry with a clean cloth.
5. Use saddle soap (never Armorall®) to condition the cover per the manufacturer’s instructions.
6. Wipe and rinse any dirt from the bottom of the cover.
7. Replace the cover and secure the locks.
Note: To remove tree sap, use lighter fluid (the type used in cigarette lighters). Use sparingly.
Immediately apply saddle soap to the area.
Bullfrog Spas Owner’s Manual
29