Bullit DVD7200BT User Manual - page 27
Page 24 of 44 pages
DVD7200BT ENGLISH
AUX IN
The AUX IN (brown connection cable) is a connection with which you can connect external
audio devices through their headphone or AUX output with this device. The audio tracks
played back on these devices are then put out through the car speakers. This is how you can
e.g. play back audio files that you have saved on your cell phone, minidisk, iPod® or tape
recorder. To connect external audio devices with the CD/DVD car radio, you will need a
cable with an RCA jack (right + left) on a 3.5 mm jack plug, which is not included in the scope
of delivery. First connect this cable to the device - and then the headphone connection or
AUX output of your playback device. Now you can start the playback. Set the volume of the
playback device to a medium level and subsequently regulate the volume with your
DVD7200BT. If the playback source of the DVD7200BT has not been set to AUX yet, please
press the “MODE” button until AUX appears on the display.
Menu settings level 1
By briefly pressing the volume control dial once or several times, the functions of menu level
1, volume control, bass setting, treble setting, and the speaker balance between the left and
right as well as front and rear speaker groups can be selected and set.
Changing the bass settings (BASS)
Pressing the volume control dial twice will result in reaching the bass settings. The message
“BAS” will appear on the display together with the current level (e.g. B. “+2”). To change the
bass bandwidth, turn the volume control dial clockwise or counter-clockwise. The bandwidth
can be set in a range between “-7” and “+7”. It can be changed in increments of one. The
setting is saved either when the desired value is confirmed by pressing the volume control
dial or through automatic memory (don’t change anything on the device for approx. five
seconds). If you confirm the selection by pressing the control dial , you will reach the next
possible setting. If you use the automatic memory, the device will return to the standard
display.
Changing the treble settings (TREBLE)
After pressing the volume control dial twice, the treble setting (TREBLE) can be reached.
The message “TRE” will appear on the display together with the current level (e.g. “0”). To
change the bandwidth of the treble, turn the control dial clockwise or counter-clockwise. The
bandwidth can be set in a range between “-7” and “+7”. It can be changed in increments of
one. The setting is saved either when the desired value is confirmed by pressing the volume
control dial or through automatic storage (don’t change anything on the device for approx.
five seconds). If you confirm the selection by pressing the volume control dial, you will reach
the next possible setting. If you use the automatic memory, the device will return to the
standard display.
Changing the volume ratio (BALANCE)
After pressing the volume control dial three times, the settings for the ratio between the
speakers connected on the right and left can be reached (BALANCE). The message “BAL”
appears on the display along with the settings for the volume ratio between the right and left
speaker group (e.g. “BAL R2”). To change the ratio between the speakers, turn the volume
control dial clockwise or counter-clockwise. Depending on the direction in which the control
dial is turned, an “R” (right speaker group) or an “L” (left speaker group) will appear on the
display, together with a digit (e.g. “R2” or “L4”). These provide information about the direction
in which the volume ratio is changed and about the amount of the change. The ratio between
the right and left speaker group can be set in a range between “8R” and “8L”. The volume
ratio between the speakers changes according to the setting and the volume will increase on
one side according to this setting and decrease on the other side. If the ratio is set to “R-L”,
the volume on both speaker groups is the same. If the control dial is set to the maximum