Summary of Axiom Series

  • Page 1

    Installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming manual, or service manual, ple...

  • Page 2

    Page 2 39130 041108 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) all equipment other than as specified below: 2 years parts and 1 year labor. 2) electronic circuit and/or control boards: parts and labor for 3 years. 3) comp...

  • Page 3

    Page 3 pn: 00658.0000g 02/08 © 1985 bunn-o-matic corporation #00658.0000 #37881.0000 39130 030508 #00986.0000 user notices carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in good condition. Replace any unreadable or damaged labels...

  • Page 4

    Page 4 electrical requirements 39130 020608 warning - the brewer must be disconnected from the power source until specified in initial set-up. Refer to data plate on the brewer, and local/national electrical codes to determine circuit requirements. Electrical hook-up (all models) caution – improper ...

  • Page 5

    Page 5 39130 020608 electrical requirements 120v ac single phase models note: this electrical service re- quires 2 current carrying conduc- tors (neutral, and l1) and a separate conductor for earth ground. N l1 g l2 red l2 red white green green neutral l1 black white neutral l2 l1 black 120v. A.C. 1...

  • Page 6

    Page 6 -1000 213.8 101.0 200 93.3 -500 212.9 100.5 200 93.3 0 212.0 100.0 200 93.3 500 211.1 99.5 200 93.3 1000 210.2 99.0 200 93.3 1500 209.3 98.5 200 93.3 2000 208.4 98.0 200 93.3 2500 207.4 97.4 200 93.3 3000 206.5 96.9 199 92.8 3500 205.6 96.4 198 92.2 4000 204.7 95.9 197 91.7 4500 203.8 95.4 19...

  • Page 7

    Page 7 operating controls (a) enable brew on/off switch pressing the "enable brew on/off" switch (indicator on) supplies power to the brew station warmer, enables the brew circuit, and energizes the tank refill circuit. Pressing the switch again (indicator off) stops tank refilling and brewing and d...

  • Page 8

    Page 8 cleaning 1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on bunn-o-matic equipment. 2. Check and clean the sprayhead. The sprayhead holes must always remain open. Insert the short end of the sprayhead cleaning tool into eac...

  • Page 9: Bunn

    Page 9 rear front warmers bunn ® warmer ™ adjustments & optional settings p3633-2 39130 053006 ready to brew water temp: 200° 1 3 2 using the menu-driven display on the front of the brewer, the operator has the ability to alter or modify various brewing parameters such as brew lockout, brew volume, ...

  • Page 10

    Page 10 39130 020608 adjustments & optional settings (cont.) brew meter 1 - + set ready: 195° (-) done (+) set temp: 200° (-) done (+) enter password 0 0 0 exiting brewwizard brew lockout ? No done yes programming functions - flow chart (cont.) brewwizard enter service #? No yes units metric done en...

  • Page 11

    Page 11 enabl energysavr no done yes drip t i m e 0:30 (-) done (+) brew counters ? No yes calibrate flow ? No yes spray oz/m: 25.0 (-) done (+) enable brewlogic no done yes 0 refill 155 (-) done (+) enabl warmer off no done yes enablefreshtimer no done yes enable clean no done yes set pulse brew ? ...