1. DL manuals
  2. Bunn
  3. Dispenser
  4. IMIX-3S+
  5. Installation & Operating Manual

Bunn IMIX-3S+ Installation & Operating Manual

Summary of IMIX-3S+

  • Page 1

    Imix ® -3s imix ® -5s installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts catalog, programming manual, ...

  • Page 2

    2 44910.1 080112 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) airpots, thermal carafes, decanters, gpr servers, iced tea/coffee dispensers, mcp/mca pod brewers thermal servers and thermofresh servers (mechanical and digital...

  • Page 3

    3 warning ! Fill water tank before turning - on - thermostat or connecting appliance to power source. Use only on a properly protected circuit capable of the rated load. Electrically ground the chassis. Follow national/local electrical codes. Do not use near combustibles. Failure to comply risks equ...

  • Page 4

    4 initial set-up 1. Apply the four non-skid pads from the parts box to the bottom of the legs. 2. Remove the drip tray assembly, drip tray bracket, and splash panel assembly from the parts box. 3. Place a set of key holes in the drip tray bracket over the lower two screws in the panel below the hopp...

  • Page 5

    5 initial fill & heat caution - the dispenser must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. 1. Turn-on the water supply and connect the dispenser to the power source. 2. Water will automatically flow into the tank to the proper l...

  • Page 6

    6 rinse timers the dispenser is shipped from the factory with the rinse timers disabled. To enable the rinse timers, remove power from the dispenser, remove the lower access panel, and remove the jumper from j1 of the control boards. Replace the lower access panel, and return power to the dispenser....

  • Page 7

    7 cleaning the use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all sur- faces on bunn-o-matic equipment. Do not clean this equipment with a water jet device. 1 x 24h 37254.0001a 06/11 © 2011 bunn-o-matic corporation notice the cleaning instructions ...

  • Page 8

    8 adjustments the beverage solenoid is preset to dispense approximately 9/10 ounce per second (26 ml/sec) or approximately 4/10 ounce per second (12 ml/sec) on non whipper models (oatmeal, etc.). This amount can be adjusted: 1. Disconnect the dispenser from the power source. 2. Remove the hoppers an...