1. DL manuals
  2. Bunn
  3. Dispenser
  4. IMIX-3S+
  5. Installation & Operating Manual

Bunn IMIX-3S+ Installation & Operating Manual

Summary of IMIX-3S+

  • Page 1

    Imix ® -3s+ imix ® -3s+a imix ® -5s+ imix ® -5s+a installation & operating guide bunn-o-matic corporation post office box 3227 springfield, illinois 62708-3227 phone: (217) 529-6601 fax: (217) 529-6644 to ensure you have the latest revision of the operating manual, or to view the illustrated parts c...

  • Page 2

    2 38987 110909 bunn-o-matic commercial product warranty bunn-o-matic corp. (“bunn”) warrants equipment manufactured by it as follows: 1) all equipment other than as specified below: 2 years parts and 1 year labor. 2) electronic circuit and/or control boards: parts and labor for 3 years. 3) compresso...

  • Page 3

    3 warning ! Fill water tank before turning - on - thermostat or connecting appliance to power source. Use only on a properly protected circuit capable of the rated load. Electrically ground the chassis. Follow national/local electrical codes. Do not use near combustibles. Failure to comply risks equ...

  • Page 4

    4 electrical requirements caution - the dispenser must be disconnected from the power source until specified in electrical hook-up. The 120 volt version of this dispenser has an attached cordset. The mating connector must be a nema 5-15r. To access terminal block for high voltage models without a co...

  • Page 5

    5 38987 022508 plumbing requirements this dispenser must be connected to a cold water system with operating pressure between 20 and 90 psi from a 1⁄2” or larger supply line. A shut-off valve should be installed in the line before the dispenser. Install a regulator in the line when pressure is greate...

  • Page 6

    6 38987 012210 running a rinse sequence 1. Place the normal/program/rinse switch (page 9) in the “rinse” position. 2. Sequentially at each position, press all of the dispense switches. The dispenser will run for 10 seconds with the hopper(s) disabled. 3. As each position is rinsed, the lcd display w...

  • Page 7

    7 cleaning the use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all sur- faces on bunn-o-matic equipment. Do not clean this equipment with a water jet device. 1 x 24h 37254.0000a 07/04 © 2004 bunn-o-matic corporation notice the cleaning instructions ...

  • Page 8

    8 adjust tank temperature adjust minimum tank ready temper- adjust hopper motor speed for station selected (-) exit (+) (-) exit (+) drink strength (-) xx (+) (-) tank temp (+) 235 refill 155 (-) exit (+) portion control ? No exit yes calibrate temperature probe set refill probe threshold select por...

  • Page 9

    9 d igital b everage c ontrol program home screen the screen above will be shown when the dispenser is ready for use. While the tank is heating, the water temperature will be displayed until the ready temperature is reached. Programming the dispenser the following function screens are in order of ap...

  • Page 10

    10 programming cup sizes - portion control models the cup size can be programmed in portion control models by “example” or “time”. Programming by ex- ample is manually pressing desired dispense button, then releasing when the desired cup size is attained. The time required to fill the cup will be st...

  • Page 11

    11 portion control ? No exit yes programming the dispenser (cont.) (-) exit (+) strength adj. ? (-) exit (+) exit yes enter password (-) xxxx (+) calibration ? Exit yes locks/disables ? Exit yes enable ads ? No exit yes enter asset # ? Exit yes enable service ? No exit yes diagnostics ? Exit yes fac...

  • Page 12

    12 (-) tank temp (+) programming the dispenser (cont.) drink strength 1 (-) xx (+) press dispense to check taste taste 1 ok ? No yes (b) adjust hopper motor speed for station selected select units eng exit metric (d) 235 refill 155 (-) exit (+) auger delay (-) .Xx sec (+) returns to (e) (page 11) go...

  • Page 13

    13 programming the dispenser (cont.) rinse alarm ? No exit yes head 1 disable ? No exit yes set password ? (-) xxxx (+) returns to (g) (page 11) test switches ? Use switch to test test heater ? Exit yes test refill ? Exit yes test hot water ? Exit yes test augers ? Dispense to test test dispense hea...