C.E.C. TL5 Owner's Manual - Maintenance of Rubber Belt
14
❸
Then mount the belt to the motor pulley groove. Using
a pair of tweezers would be easier to mount.
❹
Be sure the belt is installed at the grooves and the belt
is not twisted. Twist of the belt can be corrected easily
by using a pair of tweezers moving the center shaft by
hand.
Periodical maintenance or check is not required
for a rubber belt used for all CEC belt- drive CD
transports and players. However, the tension of the
belt may be lowered by using for years which may
result unstable reading of information on CD, noise
during music reproduction and/or jump of the music.
The replacement of the belt may solve the problem if
it comes from weaker tension of the belt.
If replacement of a belt does not solve the problem,
consult with the dealer that you have purchased.
An average of the life of a belt is 5 years. It is not
required to replace if musc reproduction goes well even
after 5 years.
Replacement of a rubber belt
No other rubber band than CEC original rubber belt
can be used for replacement. Require the CEC belt at the
dealer that you have purchased.
❶
Remove the old belt.
❷
Mount a new belt to the groove under the CD-turntable
through the clearance between pick-up cover and CD-
turntable.
pick-up cover
motor pulley
motor pulley groove
groove under CD-turntable
side view
side view
proper position of the belt after replacing
side view