CA.MI MY PRESSURE User Manual - page 16
ERROR
INDICATOR
CORRECTION
TROUBLESHOOTING
The inflation pressure in cuff is
inadequate
Wait 3 minutes before taking
another measurement. Repeat
steps listed in “Measurement
Procedures”
Diastolic pressure isn’t measured
due to movement during
measurement
Blood pressure measured is invalid
due to strong
Carefully read “Preparing to take a
Measurement” and repeat steps in
“Measurement Procedures”
The number of artery pulse wave is
too few to calculate blood
User’s artery pulse is very weak or
strong outside disturbances are
affecting measurement.
Take another measurement
Battery voltage is excessively low
Replace all the batteries
repeat the measuring process
• Between each measurement, you need 3 minutes to let blood circulation of the arm to
recover
• Since blood pressure response greatly over to minute changes in the body, it is unusual for
it to continuously remain at the same value. For this reason, it is recommended that pressure
be judged based on multiple measurement.
7. Shut down
• Press the “ON/OFF” button to switch the power off. BPM has automatic “turn off” function
that means if you forget to shut down the BPM, it can turn off the power itself about 3
minutes later
MEMORY FEATURE INSTRUCTIONS
1. How do I store measured blood pressure values?
• MY PRESSURE stores measuring results automatically after each measurement
• MY PRESSURE can store up to 90 measurements and display the average of the 3 last
measurements.
2. How do I recall previous readings from memory?
• After each measurement, press “M” button to recall the average and the latest 90 measuring
results
• Press “M” button once, LCD shows the letter “A”, and after a couple of seconds the average
of the last 3 measurements will be displayed
• Press “M” button again, LCD will show the number “1” , and after a couple of seconds the
latest measurement taken will be displayed (the most recent one)
• Press “M” button again, LCD will show the number “2” , and after a couple of seconds the
previous measurement taken will be displayed
• You can press “M” button up to 90 times to display the latest 90 measurements taken
• To delete all the 90 values, press “M” button for 5 seconds. The message “Clr” will appear
on the LCD to confirm cancellation
• If there are no measured readings in memory “M” button has no functions
• If you want to recall the memory without checking your pressure: disconnect the cuff, press
the “0/I” button and wait for about 5 seconds; “ERR” will blink on the display for about 3
seconds, then the LCD displays “0mmHg”. Now you can press “M” to recall the memory.
16