Cabletron Systems SmartSTACK ELH100 Installation And User Manual - User Access
28 ELH100-12/24TX User Interface
ELH100-12/24TX
User Access
Once a direct connection to the serial port or a Telnet connection is
established, the login screen for the on-board configuration program
appears
.
You may need to press Enter a few times to display the screen.
The default user names are “admin” and “guest,” with corresponding
default passwords “admin” and “guest.” The administrator has Read/Write
access, which allows you to read and modify hub information. The guest
has Read Only access to the management program, which allows you to
view hub information, but not modify any operating parameters.
You should define a new administrator password, record it and put it in a
safe place. From the Main Menu, select User Passwords and enter a new
password for the administrator. Passwords can consist of up to 14
alphanumeric characters and are not case sensitive.
To use the console menus, do the following:
1.
Use the cursor keys to highlight the desired option.
If the selected item is a submenu title, the submenu is displayed
when you press the Enter key.
2.
Follow the screen prompts to specify the parameter requested.
If the selected item is a parameter, the system displays a prompt for
the entry of a new parameter value. If the value entered is invalid, a
message displays, requesting you to enter a valid value.
Factory Defaults
Table 3-1 lists the default settings for the hub configuration parameters.
Each parameter can be changed via the console menus or Telnet.
Table 3-1. Factory Default Settings
A user is allowed three attempts to enter the correct
password; on the third failed attempt the current
connection is terminated.
Parameter
Default Value
BootP Enable
Yes
Port Enable
Yes
Screen Timeout
10
Send Modem Initialization String (ATQ0V0S0=1)
Yes
SNMP Public Community Name
public
Terminal Baud Rate
9600
Terminal Hardware Flow Control
No