Cabletron Systems SmartSTACK ELH100 Installation And User Manual - page 85
9033060
Web-Based Management 67
Hub Configuration
Select “Hub” then “Hub Configuration” to display hardware and firmware
configuration of the hub.
Item
Description
Hub ID
Hub identifier in stack.
Model
The model number of this hub.
Hardware Version
Version number of the hub hardware.
Repeater Serial No.
Serial number of this hub.
System Version
System firmware version.
POST Version
Version number of the Agent Module’s Power-on Self-test.
Agent Status
Indicates if an Agent Module is installed and active.
Agent Hardware
Version
Hardware version number of the Agent Module.
Agent Serial No.
Serial number of the Agent Module.
Agent MAC Address
Physical address of the active Agent Module.
Agent Baud rate
Rate at which data is sent between the Agent Module’s serial
port and the connected device. The supported baud rate is
9600 bps.
Switch Module
Indicates if a switch/media module is installed.
Number of Ports
Indicates whether this device has 12 or 24 repeater ports.