Cabletron Systems SmartSTACK ELH100 Installation And User Manual - page 87
9033060
Web-Based Management 69
Port Configuration
Select “Port” then “Port Configuration” to display information about the
port’s connection, or to display/configure the port’s security setting.
Item
Description
Hub ID
Hub identifier in the stack.
Port ID
Port number to configure.
Current Speed
Indicates the transmission speed currently used by this port.
Set Speed
Selects the port speed, 100 Mbps, 10 Mbps or Auto-Detected.
Admin State
Allows you to disable a port due to abnormal behavior (e.g.,
excessive collisions), then re-enable it after the problem has
been resolved. You may also disable a port for security reasons.
Link State
Indicates if the port has a valid connection to an external device.
Partition State
Indicates if the port is partitioned.
Port Security Setting
Authentication
Address
MAC address of the device authorized to access this port.
Auto-Learn Action
When active, the authorized address is copied from the device
currently attached to this port.
Auto-Learn Status
Displays Auto-Learn status as Inactive, Active or Learned.
Intrusion
One of these actions can be selected if intrusion is detected:
INACTIVE - Detection disabled.
WARNING AND DISABLE - Sends a message to Trap
Managers and disables the violated port.