Caliber HBC 431DAB-BT Instruction Manual - Instruction Manual
INSTRUCTION MANUAL
HBC 431DAB-BT - DAB+/DAB / FM / BT / USB & CD/MP3 Boom Box
Signal error
This is displayed as a number between 0-99. It would not be possible to satisfactorily listen to a radio
station with a signal error rate of 30 or above. Try adjusting the antenna or relocating your radio to
improve reception.
Audio bit rate
The display will show the digital audio bit rate being received.
Time and date
The time and date will be automatically updated by the broadcasted information; it is no need to set
the clock manually.
FM MODE
1. To select FM, repeatedly press the Standby/MODE button until the display shows “FM”. The
display will show the frequency and the RDS info if available. To go through the RDS info,
repeatedly press the INFO/MENU button.
2. To perform manual tuning, repeatedly press the ◄ or ► button, when your desired frequency
appears in the display, release the buttons.
3. To activate auto scan for stations, press and hold the ◄ or ► button until it starts to scan down
or up the frequency band, the display will show “Scanning …”, and it will stop automatically once
a station has been found.
4. To enter into the FM Menu, press and hold the INFO/MENU button, then press the ◄ or ► button
followed by pressing the SELECT button to select
Scan setting - Strong stations only / All stations
Audio setting - Stereo allowed / forced mono
Note: An “*” will be displayed to indicate the current setting.
STORING AND RECALLING STORED STATIONS
In either DAB or FM mode, you can store up to 20 stations to the favorite presets; this will enable you
to get direct access to your favorite stations.
1. To store a preset, first tune to your desired station, then press and hold the PRESET/ALBUM button,
the display will show “Preset Store <1: (Empty) >”.
2. Press the ◄ or ► button to select your desired station preset number and then press the SELECT
button to confirm your selection, the display will show “Preset # stored”.
3. To recall a preset station, first press on the PRESET/ALBUM button once, and when the display
shows “Preset Recall”, press the ◄ or ► button to scroll up or down the presets that you have
stored, when you see your desired preset number in the display, press the SELECT button.