Caliber HBC 431DAB-BT Instruction Manual - Instruction Manual
INSTRUCTION MANUAL
HBC 431DAB-BT - DAB+/DAB / FM / BT / USB & CD/MP3 Boom Box
Note: An “*” will be displayed to indicate the current setting.
Factory Reset
You can reset your radio and restore all of the original factory settings.
To perform factory reset, select
mode and perform auto scan function, the display will show ”Restarting ...” and then ”Scanning ...”,
after the reset is completed, the unit will stay in DAB mode.
Note: All of your stored DAB & FM presets will be deleted once the reset has taken place.
SW Version
The SW version will be displayed and you may wish to take a note here.
LISTENING TO YOUR RADIO
HINTS FOR BETTER RECEPTION
This radio is fitted with a single DAB/FM telescopic antenna, to obtain the best performance, you
should fully extend the antenna and adjust its position as well as the direction until you find the best
reception. For ideal DAB reception, always maintain the antenna in an upright vertical position is highly
recommended.
DAB MODE
If the unit is switched on for the first time, it will automatically enter into the DAB mode and perform
auto scan function. During the scan the display will show “Scanning …” together with a slide bar that
indicates the progress of the scan and the amount of stations that have been found so far.
Once the scan has finished, the radio will select the first alphanumerically found station. You can now
press the ◄ or ► button to explore the found stations followed by pressing the SELECT button to select
listening to your desired station.
To select DAB mode during other operation modes, repeatedly press the Standby/MODE button until
the display shows “DAB”.
To enter into the DAB Menu, press and hold the INFO/MENU button, then repeatedly press the ◄ or
►
button to step through the following sub menus: Full scan / Manual tune / DRC / Prune / System
Full scan
The full scan will search for the entire DAB Band III channels. After the scan has finished, the first
alphanumerically found station will be automatically selected.
1. To activate full scan, press on the SCAN button once, the display will show “Scanning …” and a
progressing slide bar.
2. All the stations that have been found will be stored automatically, to explore the stations that have