Cambridge Audio Incognito LM10 Installation Manual - page 15
Incognito LM10
Incognito LM10 15
SOURCE ROTATE FOR LOCAL 1&2 ON THE KEYPAD
Note: This feature is only available if the KP10 is
part of a full Incognito multi-room system with one
or two Local Input Modules (LM10) fitted.
The local source selection mode will need to be
activated to configure the KP10 correctly. This
mode is only available when the Mode Switch is
set to “AH10” mode. LM10s can only be used in
this mode. Please refer to your LM10 Installation
Guide for more information.
Pressing the Select left or right buttons on the key-
pad allows you to rotate through all six sources as
default. However, it is possible to allow the addi-
tion of one or two local sources by accessing Local
source selection mode. To enter this mode press
the Volume up button simultaneously with the
Power button for four seconds; the LED display will
then scroll through the sequence shown in the
illustration right and described as follows:
After holding both buttons down for a short period,
LED 2 will light indicating that Sources 1–6
(default) are available for selection.
2
3
4
5