Cambridge Audio Incognito LM10 Installation Manual - page 7
Incognito LM10
Incognito LM10 7
SAFETY PRECAUTIONS
Avoid placing the LM10 near to dimmer switches or other items, which generate a lot of
electrical noise. Avoid fitting the LM10 in areas of high humidity.
The LM10 runs on 24V DC supplied through the connecting cable. As such there is no mains volt-
age present in the LM10 and the unit is often safe to fit in areas where only extra low voltage
(ELV) equipment is permitted. However, it is imperative that you always check the wiring regula-
tions in force for your application and area.
FACEPLATES
The LM10 faceplate system is based on the (LM10-EU=50x50 ‘easy-clip’ module, LM10-
CU=Decora
TM
) standard and is interchangeable for the wide range of faceplates made by manu-
facturers such as (LM10-EU=MK Electric, RPP etc, LM10-CU=Leviton etc) that conform to this
standard. If it is desired to fit another faceplate, it can be replaced by gently prising apart the
LM10 faceplate and snapping on another in its place.
WIRING GUIDE: EIA/TIA 568A WIRING STANDARD
View from
contact end
Gather pairs, trim and
insert into RJ45 plug
Crimp wires
securely in place
brown
white/brown
orange
white/blue
blue
white/orange
green
white/green